Reduce downtime of your vehicle with the new cleaning technology of Advanpure for several years be used diesel particulate filters in diesel engines. The proportion of DPF in new vehicles or retrofitting is increasing in the area of passenger cars steadily, with only diesel particulate filters are used in commercial vehicles. With the introduction of the EURO 6 standard (from 2014) no manufacturer of diesel engines is do without more on the use of a diesel particulate filter. Attorney General may help you with your research. A major component of the exhaust gases of combustion consists of environmentally harmful soot particles which are deposited on the surface or on the inside of the filter function of DPF. By the deposition of the particles increases the differential pressure generated by the waste gas volume flow through the filter.
A certain threshold is reached, so a certain soot in the filter stored is the regeneration of the filter will be initiated. Certain exhaust gas temperatures are needed for the regeneration process. In favorable circumstances (Highway mode) this re genera sound intervals are large or are not needed, because higher exhaust gas temperatures. It becomes problematic in the short haul, here, there may be an increased loading of the filter and get the regeneration temperature is not reached. This in turn causes that due to the high amount of soot the filter clogged”, the differential pressure increases, decreases engine performance and increases fuel consumption. Here are two options to consider, a more expensive replacement or but cost effective cleaning of the filter come for the vehicle owner. u0085and right here is the new technology of ADVANPURE! The motto is: fast clean inexpensive; The environment for your sake! Diesel particulate filter cleaning by many years of experience and research in the area of clean technology, has the Advanpure UG developed a new method to the diesel particulate filter (DPF) cleaning.
Advanpure 3-phase cleaning technology the quality of the particle filter cleaning will be tested in three phases (basic cleaning, treatment, function test) and could precisely each other coordinated processes on 95% of the original capacity be increased. This technology makes it possible to clean the Advanpure UG not only diesel particulate filters of all common types of vehicles (automobiles, trucks, buses, construction equipment and CHP), allows it to also do this in a very short time. For example, losses are possible for car cleaning periods of 70-120 minutes without any qualitative. The downtime of the vehicle is thus reduced to a minimum. By removing the cleaning to the Assembly Advanpure is on your side.